Manufacturer — Base King
The bond comes pre-applied.
Base King makes EnviroSTIX — an aggressive poly-acrylic adhesive applied by machine directly to the backing of commercial flooring materials before they reach the site. Peel, place, roll: no open trowels, no flash time, no adhesive odor holding a space out of service. For architects and designers specifying occupied renovations, it changes what a floor replacement asks of the building.
Floors go down and rooms go back to work — no cure window, no odor complaint.
01 — ES-100 system
Built for the humid slab.
ES-100 is the newest peel-and-bond system in the line, created for the most challenging projects — slabs holding high relative humidity that would stall a conventional wet-adhesive install. A dedicated moisture-barrier primer prepares the substrate; the pre-applied adhesive does the rest.
Prep and prime, peel and install, roll. The whole method fits in one diagram.
Carpet tile, LVT, sheet, and rubber — each backing leaves the factory ready to bond.
Poly-acrylic
An aggressive bond, applied by machine at the factory — not troweled on site.
High-RH ready
ES-100 was created for slabs holding high relative humidity, primer included.
10+ years proven
The Classic system has been in the field for over a decade.
Acoustic + impact
ES-Cushion and ES-Barrier add performance layers as they bond.
Technical documentsSpecification guides and technical data sheets for Base King and EnviroSTIX.
02 — EnviroSTIX Classic
A decade of proof.
EnviroSTIX Classic is the original peel-and-bond system, and it has carried time-sensitive, budget-tight, and otherwise difficult projects for more than ten years. Carpet tile, LVT plank, sheet goods, and rubber tile each have their own published installation instructions — the system is documented, not improvised.
The backing arrives with the adhesive already on it — the installer’s job is placement, not chemistry.
Documentation
Written for the spec.
Specification guides, installation instructions by flooring type, safety data sheets, and warranties are published for every system. Start with the ES-100 specification guide and the EnviroSTIX system specification guide — both formatted for your spec sections.
The bond ships on the backing — the schedule never waits for the floor.
03 — ES-2-GO
The machine does the spreading.
ES-2-GO applies adhesive from rolls through a purpose-built machine, bringing the factory’s consistency onto the site itself. Coverage is uniform by mechanism rather than by an installer’s wrist — the variable that decides most adhesive failures is removed from the sequence.
Adhesive rolls feed through the applicator — coverage is uniform by mechanism.
04 — Cushion & Barrier
Acoustics and moisture, in one layer.
ES-Cushion and ES-Barrier are pre-cured adhesive systems for high-moisture conditions that add acoustic and impact performance while they bond. Where a project would otherwise stack a separate underlayment beneath the floor, the adhesive layer itself does that work.
The acoustic layer and the bond, delivered as one roll.
Moisture protection cast into the adhesive sheet itself.
Sampling
Test it on your substrate.
Request adhesive-backed samples and the system recommendation for your slab conditions — proven on your substrate, not in a brochure.
Every project starts with a conversation.
One dedicated account executive carries your project from first sample to final walkthrough — one contact, start to finish.
CONTACT YOUR ACCOUNT EXECUTIVE →EXPLORE ALL PRODUCT LINES →